close
Fluoropolymer Products
& Applications

FEP PELLET

FEP PELLET

  • FEP Wire and Cable Insulation

  • FEP Tubing extrusion and injection molding

  • FEP Lining and molding

About DASFLON™ FEP PELLET

Our DASFLON™ FEP is widely used in wire and cable insulation and tubing extrusion applications attributable to a stable melt flow rate.

General characteristics

  • Excellent flowability during the extrusion process

  • Highly stable melt flow rate

  • Excellent thermal stability

  • Continuous service temp up to 260 °C

  • Low dielectric constant

  • Resistance to corrosion, heat and flame, UV

  • Low coefficient of friction

  • Very low moisture absorption

EXPANDED ADVANTAGES

  • Melt Flow Adjustment We offer customization to meet your specific Melt Flow Rate (MFR). Whether it is your exact target or a close approximation, we will ensure you receive the MFR you need.

  • Micro Pellet Availability For precise feeding in small extruders, we recommend using our smaller-sized FEP pellets, available in diameters ranging from 0.8mm to 2.0mm.

  • RTU (Ready-to-Use) Colored Pellets Customization options for our ready-to-use colored pellets are available and can be tailored through further discussion with customers.

  • Custom compounding We offer high-level fluoropolymer compounding service using our advanced dispersing technologies, Please contact us for more details.

  • Attractive Pricing Our FEP products are offered at a highly competitive prices, delivering the same high quality you previously paid premium for.

The table below outlines the physical properties of our standard grades

Thermal and mechanical
Property Test Method Units CJ-2 CJ-3 CJ-7 CJ-15 CJ-25 CJ-30
Melt Flow Rate ASTM D-2116 g/10 min 1.0 ~ 1.5 2.0 ~ 3.5 5.5 ~ 8.0 10 ~ 15 22 ~ 28 30 ~ 38
Melting Point ASTM D-2116 DSC ℃ - - 260 ~ 270 ℃ - - -
Elongation ASTM D-2116 % 320 300 300 280 290 290
Tensile Strength ASTM D-2116 Mpa 26 25 21 20 19 19

* Besides the above grades, we can meet your target Melt Flow Rate(MFR) If you require specific MFR.
Remark: CJ-2 can be also used for extrusion and compression molding.
CJ-3 was developed for the extrusion of cable jackets and tubing.

Application

  • CJ-2 : Transfer molding

  • CJ-3 : Tubing

  • CJ-7 : Tubing and Cable jacket

  • CJ-15 : Wire and Cable Insulation (medium flow)

  • CJ-25 : Wire and cable insulation (relatively high-speed extrusion)

  • CJ-30 : Wire and cable insulation (high-speed extrusion)

Packaging

25kgs (55 lbs) paper bag (inner sealed plastic layers shielded by three paper layers)
Gaylord box : 500Kg (1102 lbs), 1000kg(2204 lbs)